Based Box

Fully closed box on a base

This box is more of a building block than a finished item. Use a vector graphics program (like Inkscape) to add holes or adjust the base plate. The width of the "brim" can also be adjusted with the **edge_width** parameter in the **Finger Joints Settings**. See ClosedBox for variant without a base.

Viewed:

Layouts generated:

Settings for Finger Joints

angle
style style of the fingers
surroundingspaces minimal space at the start and end in (multiple of normal spaces)
edge_width space below holes of FingerHoleEdge (multiples of thickness)
extra_length extra material to grind away burn marks (multiples of thickness)
finger width of the fingers (multiples of thickness)
play extra space to allow finger move in and out (multiples of thickness)
space space between fingers (multiples of thickness)
width width of finger holes (multiples of thickness)

Main Settings

x inner width in mm (unless outside selected)
y inner depth in mm (unless outside selected)
h inner height in mm (unless outside selected)
outside treat sizes as outside measurements

Default Settings

thickness thickness of the material in mm
format format of resulting file
tabs width of tabs holding the parts in place in mm (not supported everywhere)
debug print surrounding boxes for some structures
labels label the parts (where available)
reference print reference rectangle with given length in mm (zero to disable)
inner_corners style for inner corners
burn burn correction in mm (bigger values for tighter fit)

Online Box generator :: Based Box - Fully closed box on a base