Shelf for holding (multiple) piles of playing cards / notes
inside angle of the feet
height of strips to be glued to the inside of bottom edges (multiples of thickness)
height of the feet (multiples of thickness)
distance from finger holes to bottom edge (multiples of thickness)
width of the feet (multiples of thickness)
the angle of arc cuts
the gap between grooves (fraction of the edge length)
alternate the direction of grooves
invert the groove directions
minimum space left and right without grooves (fraction of the edge length)
the style of grooves
the angle of triangular cuts
the width of each groove (fraction of the edge length)
style of the fingers
space at the start and end in multiple of normal spaces
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
width of the fingers (multiples of thickness)
extra space to allow finger move in and out (multiples of thickness)
space between fingers (multiples of thickness)
width of finger holes (multiples of thickness)
sections left to right in mm
inner depth in mm (unless outside selected)
inner height in mm (unless outside selected)
treat sizes as outside measurements
backward angle of floor
make holders stackable
thickness of the material in mm
format of resulting file
width of tabs holding the parts in place in mm (not supported everywhere)
Add a QR Code with link or command line to the generated output
print surrounding boxes for some structures
label the parts (where available)
print reference rectangle with given length in mm (zero to disable)
style for inner corners
burn correction in mm (bigger values for tighter fit)
Generate Download Save to URL QR Code
