Castle

Castle tower with two walls

This was done as a table decoration. May be at some point in the future someone will create a proper castle with towers and gates and walls that can be attached in multiple configurations.

Viewed:

Layouts generated:

Settings for Finger Joints

angle
style style of the fingers
surroundingspaces minimal space at the start and end in (multiple of normal spaces)
edge_width space below holes of FingerHoleEdge (multiples of thickness)
extra_length extra material to grind away burn marks (multiples of thickness)
finger width of the fingers (multiples of thickness)
play extra space to allow finger move in and out (multiples of thickness)
space space between fingers (multiples of thickness)
width width of finger holes (multiples of thickness)

Default Settings

thickness thickness of the material in mm
format format of resulting file
tabs width of tabs holding the parts in place in mm (not supported everywhere)
debug print surrounding boxes for some structures
labels label the parts (where available)
reference print reference rectangle with given length in mm (zero to disable)
inner_corners style for inner corners
burn burn correction in mm (bigger values for tighter fit)

Online Box generator :: Castle - Castle tower with two walls