A parameterized Gridfinity base
This is a configurable gridfinity base. This design is based on Zach Freedman's Gridfinity system
style of the fingers
space at the start and end in multiple of normal spaces
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
width of the fingers (multiples of thickness)
extra space to allow finger move in and out (multiples of thickness)
space between fingers (multiples of thickness)
width of finger holes (multiples of thickness)
type of lid to create
height of the handle (if applicable)
height of the brim (if any)
play when sliding the lid on (if applicable)
number of grids in X direction
number of grids in Y direction
height of sidewalls of the tray (mm)
Extra margin around the gridfinity base to allow it to drop into the carrier (mm)
edge type for bottom edge
The Gridfinity pitch, in mm. Should always be 42.
The cutout for each grid opening. Typical is 38.
thickness of the material in mm
format of resulting file
width of tabs holding the parts in place in mm (not supported everywhere)
Add a QR Code with link or command line to the generated output
print surrounding boxes for some structures
label the parts (where available)
print reference rectangle with given length in mm (zero to disable)
style for inner corners
burn correction in mm (bigger values for tighter fit)
Generate Download Save to URL QR Code