Smartphone desk holder
This phone stand holds your phone between two tabs, with access to its bottom, in order to connect a charger, headphones, and also not to obstruct the mic. Default values are currently based on Galaxy S7.
style of the fingers
space at the start and end in multiple of normal spaces
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
width of the fingers (multiples of thickness)
extra space to allow finger move in and out (multiples of thickness)
space between fingers (multiples of thickness)
width of finger holes (multiples of thickness)
Height of the phone.
Width of the phone.
Depth of the phone. Used by the bottom support holding the phone, and the side tabs depth as well. Should be at least your material thickness for assembly reasons.
angle at which the phone stands, in degrees. 0° is vertical.
Height of the support below the phone
Length of the tabs holding the phone
Spacing between the two bottom support. Choose a value big enough for the charging cable, without getting in the way of other ports.
thickness of the material in mm
format of resulting file
width of tabs holding the parts in place in mm (not supported everywhere)
Add a QR Code with link or command line to the generated output
print surrounding boxes for some structures
label the parts (where available)
print reference rectangle with given length in mm (zero to disable)
style for inner corners
burn correction in mm (bigger values for tighter fit)
Generate Download Save to URL QR Code
