+7 (953) 49 555 44
info@laserbiz.ru
Заказать звонок

back to generator Catalog

TrayLayout

Generate a typetray from a layout file.

This is a two step process. This is step 2. Edit the layout text graphics to adjust your tray. Put in the sizes for each column and row. You can replace the hyphens and vertical bars representing the walls with a space character to remove the walls. You can replace the space characters representing the floor by a "X" to remove the floor for this compartment.

Viewed:

Layouts generated:

Settings for Finger Joints

angle

style

style of the fingers

surroundingspaces

space at the start and end in multiple of normal spaces

bottom_lip

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

edge_width

space below holes of FingerHoleEdge (multiples of thickness)

extra_length

extra material to grind away burn marks (multiples of thickness)

finger

width of the fingers (multiples of thickness)

play

extra space to allow finger move in and out (multiples of thickness)

space

space between fingers (multiples of thickness)

width

width of finger holes (multiples of thickness)

Settings for the Lid

handle

style

type of lid to create

handle_height

height of the handle (if applicable)

height

height of the brim (if any)

play

play when sliding the lid on (if applicable)

Main Settings

inner height in mm (unless outside selected)

inner height of inner walls in mm (unless outside selected)(leave to zero for same as outer walls)

outside

treat sizes as outside measurements

sections left to right in mm

sections back to front in mm

layout

Default Settings

thickness

thickness of the material in mm

format

format of resulting file

tabs

width of tabs holding the parts in place in mm (not supported everywhere)

qr_code

Add a QR Code with link or command line to the generated output

debug

print surrounding boxes for some structures

labels

label the parts (where available)

reference

print reference rectangle with given length in mm (zero to disable)

inner_corners

style for inner corners

burn

burn correction in mm (bigger values for tighter fit)