Box various options for different stypes and lids
style of the fingers
space at the start and end in multiple of normal spaces
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
width of the fingers (multiples of thickness)
extra space to allow finger move in and out (multiples of thickness)
space between fingers (multiples of thickness)
width of finger holes (multiples of thickness)
inside angle of the feet
height of strips to be glued to the inside of bottom edges (multiples of thickness)
height of the feet (multiples of thickness)
distance from finger holes to bottom edge (multiples of thickness)
width of the feet (multiples of thickness)
have lid overlap at the sides (similar to OutSetEdge)
set to lower value to get disks surrounding the pins
"outset" or "flush"
diameter of the pin hole (multiples of thickness)
fixed length of the grips on he lids (multiples of thickness)
thickness of the arc holding the pin in place (multiples of thickness)
diameter of the pin hole in mm
pieces per hinge
number of hinges per edge
style of hinge used
radius of the eye (multiples of thickness)
space between eyes (multiples of thickness)
minimum space around the hinge (multiples of thickness)
width of the "finger hole" in mm
additional pin for better positioning
position(s) of the extra locking springs in the lid
angle of the hooks bending outward
radius at the bottom (multiples of thickness)
length of the hooks (multiples of thickness)
height above the wall
radius of hole
radius of top corner
extend the triangle along the length of the edge (multiples of thickness)
head diameter of mounting screw in mm
shaft diameter of mounting screw in mm
minimum space left and right without holes (fraction of the edge length)
number of mounting holes (integer)
side of box (not all valid configurations make sense...)
edge style
height above the wall in mm
height of hole(s) in percentage of maximum hole height (handle height - 2 * material thickness)
width of hole(s) in percentage of maximum hole width (width of edge - (n+1) * material thickness)
added to side panels if checked, to front and back otherwise (only used with top_edge parameter)
radius of corners in mm
extend the handle along the length of the edge (multiples of thickness)
Hint of how much the flex part should be shortened
width of the gaps in the cuts (multiples of thickness)
width of the pattern perpendicular to the cuts (multiples of thickness)
width of the pattern in direction of the cuts (multiples of thickness)
type of lid to create
height of the handle (if applicable)
height of the brim (if any)
play when sliding the lid on (if applicable)
edge type for top edge
inner width in mm
inner depth in mm
inner height in mm
radius of bottom corners
thickness of the material in mm
format of resulting file
width of tabs holding the parts in place in mm (not supported everywhere)
Add a QR Code with link or command line to the generated output
print surrounding boxes for some structures
label the parts (where available)
print reference rectangle with given length in mm (zero to disable)
style for inner corners
burn correction in mm (bigger values for tighter fit)
Generate Download Save to URL QR Code
