Wall Type Tray

Type tray - allows only continuous walls

Viewed:

Layouts generated:

Settings for Finger Joints

angle
style style of the fingers
surroundingspaces minimal space at the start and end in (multiple of normal spaces)
edge_width space below holes of FingerHoleEdge (multiples of thickness)
extra_length extra material to grind away burn marks (multiples of thickness)
finger width of the fingers (multiples of thickness)
play extra space to allow finger move in and out (multiples of thickness)
space space between fingers (multiples of thickness)
width width of finger holes (multiples of thickness)

Settings for plain WallEdges

edge_width space below holes of FingerHoleEdge (multiples of thickness)

Settings for SlatWallEdges

bottom_hook "spring", "stud" or "none"
hook_depth horizontal width of the hook
pitch vertical spacing of slots middle to middle in mm
edge_width space below holes of FingerHoleEdge (multiples of thickness)
hook_extra_height space surrounding connectors (multiples of thickness)

Settings for DinRailEdges

bottom "stud" or "none"
depth horizontal width of the hook
edge_width space below holes of FingerHoleEdge (multiples of thickness)

Settings for FrenchCleatEdges

angle angle of the cut (0 for horizontal)
bottom "stud", "hook" or "none"
depth horizontal width of the hook in mm
spacing distance of the cleats in mm (for bottom hook)
edge_width space below holes of FingerHoleEdge (multiples of thickness)

Settings for Stackable Edges

angle inside angle of the feet
height height of the feet (multiples of thickness)
holedistance distance from finger holes to bottom edge (multiples of thickness)
width width of the feet (multiples of thickness)

Main Settings

walltype Type of wall system to attach to
sx sections left to right in mm
sy sections back to front in mm
h inner height in mm (unless outside selected)
hi inner height of inner walls in mm (unless outside selected)(leave to zero for same as outer walls)
outside treat sizes as outside measurements
bottom_edge edge type for bottom edge
back_height additional height of the back wall
radius radius for strengthening walls with the hooks

Default Settings

thickness thickness of the material in mm
format format of resulting file
tabs width of tabs holding the parts in place in mm (not supported everywhere)
debug print surrounding boxes for some structures
labels label the parts (where available)
reference print reference rectangle with given length in mm (zero to disable)
inner_corners style for inner corners
burn burn correction in mm (bigger values for tighter fit)

Online Box generator :: Wall Type Tray - Type tray - allows only continuous walls