Поддон с разделителями
Коробка с переставными разделителями
Adding '0:' at the start of the sy parameter adds a slot at the very back. Adding ':0' at the end of sy adds a slot meeting the bottom at the very front. This is especially useful if slot angle is set above zero. There are 4 different sets of dividers rendered: * With asymmetric tabs so the tabs fit on top of each other * With tabs of half wall thickness that can go side by side * With tabs of a full wall thickness * One single divider spanning across all columns You will likely need to cut each of the dividers you want multiple times.
Просматривали:
Создано макетов: