назад в Каталог генераторов


JointPanel

Create pieces larger than your laser cutter by joining them with Dove Tails

Параметры соединений

Уголhow much should fingers widen (-80 to 80)
Глубинаhow far the dove tails stick out of/into the edge (multiples of thickness)
Радиусradius used on all four corners (multiples of thickness)
Размерfrom one middle of a dove tail to another (multiples of thickness)

Основные Параметры

sxСекции по горизантали в мм
Пример:
50*4 - 4 секции по 50 мм
250/3 - Ширина разделенная на количество секций
30:25:70 - Разные размеры для каждой секции (разделитель ':' ). 3 секции шириной 30мм, 25мм и 70мм

syСекции по вертикали в мм
Отделить Разделить детали для вырезания

Общие Параметры

ТолщинаТолщина материала в мм
Формат Формат файла для вывода
ПеремычкиШирина перемычек в мм, чтобы деталь не выпадала при резке (поддерживается не везде)
Отладка Отладочная информация
Метка Подписать детали (работает не везде)
referenceprint reference rectangle with given length (zero to disable)
Внутр. угол Стиль внутренних углов
КоррекцияКоррекция реза лазером в мм (большие значения для более плотной посадки в пазы)

JointPanel

This can be used to just create a big panel in a smaller laser cutter. But the actual use is to split large parts into multiple smaller pieces. Copy the outline onto the sheet and then use the pieces to cut it into multiple parts that each can fit your laser cutter. Note that each piece must be cut with the sheet surrounding it to ensure the burn correction (aka kerf) is correct. Depending on your vector graphics software you may need to duplicate your part multiple times and then generate the intersection between one copy and each rectangular part.

The Boxes.py drawings assume that the laser is cutting in the center of the line and the width of the line represents the material that is cut away. Make sure your changes work the same way and you do not cutting away the kerf.

Small dove tails make it easier to fit parts in without problems. Lookout for pieces cut loose where the dove tails meet the edge of the parts. Move your part if necessary to avoid dove tails or details of your part colliding in a weird way.

For plywood this method works well with a very stiff press fit. Aim for needing a hammer to join the pieces together. This way they will feel like they have been welder together.